Modem Setup:

 

1. Installing Phone Filters:

 

You must install the included Phone Line Filters on every device (phones, fax machine, satellite receivers etc.) that is connected to the same line as your new DSL.

 

 

2. Installing DSL Modem



1. Plug the included Phone Line Splitter into your Wall Jack. If you are going to be using another device (phone, fax machine, satellite receiver etc.) plug-in one of your Phone Line filters into the Splitter and then plug your phone into the filter. On the other side of the splitter hookup your DSL modem directly with the supplied phone cable. Be sure to plug it into the LINE or DSL port on the back of your modem.
2. Make sure your computer is turned off.
3. Take the supplied Ethernet cable and plug it into the LAN or ETHERNET port on the back of the modem. Plug the other end of the cable into the Ethernet port on the computer.
4. Plug the supplied power cord into the modem and then into an available plug nearby. Once you plug-in the power supply, the modem will turn on automatically. If there is a switch on the back of the modem make sure to flip it to the ON position.

5. Once the READY, SYNC/PPPoE or LINE light on the front of the modem stops blinking, turn your computer on and you will be ready to surf the internet!

6. If the READY, SYNC/PPPoE or LINE light continues to blink for longer than a few minutes and it is PAST your scheduled due date for DSL, please call our Technical Support (570-893-8111)

 

 

 

Create a DSL client connection (Windows XP)

You can install the DSL client just like you install any other dial-up networking connection. To create a DSL client connection, follow these steps:

1.

Click Start, click Control Panel, and then double-click Network and Internet Connections.

2.

Click Network Connections, and then click Create a new connection in the Network Tasks pane.

3.

After the Network Connection Wizard starts, click Next.

4.

Click Connect to the Internet, and then click Next.

5.

Click Set up my connection manually, and then click Next.

6.

Click Connect using a broadband connection that requires a user name and password, and then click Next.

7.

Type KCnet DSL, and then click Next.

8.

Type the user name that KCnet provided.

9.

Type the password that KCnet provided.

10.

Type the password one more time to confirm it, and then click Next.

11.

Click Add a shortcut to this connection to my desktop.

12.

Click Finish to complete the wizard.